Technical Data Sheets
Measured values for every material, in one table.
Every property the manufacturer publishes for the five powders in the library, in one table, alongside the condition each was measured under. The values needed for design validation and specification work are on this page, and you can save it as a Modifuse-headed technical data sheet in PDF.
The prepared data sheet carries the whole table below as a single Modifuse-headed page. Alternatively you can print this page to PDF, which always carries the current figures from the site.
| PROPERTY | Nylon 12 | Nylon 11 | Nylon 12 GF | Nylon 11 CF | TPU 90A | CONDITION |
|---|---|---|---|---|---|---|
| Tensile StrengthMPa | 50 | 49 | 38 | 69 | 7.2 | — |
| Elongation at Break% | 11 | 40 | 4 | 9 | 110 | — |
| Flexural ModulusMPa | 1600 | 1400 | 2400 | 4200 | — | — |
| Notched Impact StrengthJ/m | 32 | 71 | 36 | 74 | — | — |
| Heat Deflection Temperature°C | 171 | 182 | 170 | 188 | — | 0.45 MPa |
| Tensile ModulusMPa | 1850 | 1600 | 2800 | 5300 | — | — |
| Flexural StrengthMPa | 66 | 55 | 56 | 110 | — | — |
| Heat Deflection Temperature°C | 87 | 46 | 113 | 178 | — | 1.8 MPa |
| HardnessShore A | — | — | — | — | 90 | — |
| Tear StrengthkN/m | — | — | — | — | 39 | — |
| Stress at ElongationMPa | — | — | — | — | 7 | %100 |
| Compression Set% | — | — | — | — | 59.9 | 70°C / 22 h |
Values are Formlabs’ published typical figures for printed, post-processed specimens. A dash means the property is not quoted for that material by the manufacturer. Part geometry, wall thickness and print orientation all affect real figures; for critical applications we recommend validating on the finished part.
Five Powders, One Set of Axes
Each profile is scaled against the material that leads on that axis, so the shapes show position within the range rather than absolute values. Sitting inside on one axis does not mean a material is weak there, only that the property is not what it was designed around.
- Nylon 12
- Nylon 11
- Nylon 12 GF
- Nylon 11 CF
- TPU 90A
Send us your CAD file for a technical quote.
- STEP / STP / STL
- 24-hour response
- NDA protected